Table des Matières
Publicité
Å
ı
FRONT BRAKE AND REAR BRAKE
5 - 25
2. Air bleed:
Brake system
G
Refer
to
"BRAKE
BLEEDING" section in the CHAPTER
3.
3. Inspect:
Brake fluid level
G
Fluid at lower level → Fill up.
Refer
to
"BRAKE
INSPECTION" section in the CHAP-
TER 3.
4. Install:
[Front]
Reservoir float
G
Diaphragm
G
Brake master cylinder cap 1
G
Screw (brake master cylinder cap) 2
G
2 Nm (0.2 m · kg, 1.4 ft · lb)
[Rear]
Diaphragm
G
Brake master cylinder cap 1
G
Bolt (brake master cylinder cap) 2
G
2 Nm (0.2 m · kg, 1.4 ft · lb)
CAUTION:
After installation, while pulling the brake
lever in or pushing down on the brake
pedal, check whether there is any brake
fluid leaking where the union bolts are
installed respectively at the brake master
cylinder and brake caliper.
Å Front
ı Rear
5. Install: (rear brake only)
Protector 1
G
Bolt (protector) 2
G
7 Nm (0.7 m · kg, 5.1 ft · lb)
CHAS
SYSTEM
AIR
FLUID
LEVEL
Publicité
Table des Matières
