Yamaha YZ250F 2004 Manuel D'atelier Du Proprietaire page 39

Masquer les pouces Voir aussi pour YZ250F 2004:

Table des Matières

YU-33975, 90890-01403

YM-01442, 90890-01442

YM-01494, 90890-01494

YU-3112-C, 90890-03112

YM-33277-A, 90890-03141 Timing light

YM-4019, 90890-04019

YM-91042, 90890-04086

YM-4111, 90890-04111

YM-4116, 90890-04116

YM-4112, 90890-04112

YM-4117, 90890-04117

Tool name/How to use

Steering nut wrench

This tool is used when tighten the steering ring nut to

specification.

Fork seal driver

This tool is used when install the fork oil seal.

Damper rod holder

Use this tool to remove and install the damper rod.

Pocket tester

Use this tool to inspect the coil resistance, output

voltage and amperage.

This tool is necessary for checking ignition timing.

Valve spring compressor

This tool is needed to remove and install the valve

Clutch holding tool

This tool is used to hold the clutch when removing or

installing the clutch boss securing nut.

Valve guide remover

Intake 4.0 mm (0.16 in)

Exhaust 4.5 mm (0.18 in)

This tool is needed to remove and install the valve

Valve guide installer

Intake 4.0 mm (0.16 in)

Exhaust 4.5 mm (0.18 in)

This tool is needed to install the valve guide.

SPECIAL TOOLS

Illustration