Yamaha YZ250F 2004 Manuel D'atelier Du Proprietaire page 36

CHECKING OF CONNECTION
EC1C0001
CHECKING OF CONNECTION
Dealing with stains, rust, moisture, etc. on the
connector.
1. Disconnect:
2. Dry each terminal with an air blower.
3. Connect and disconnect the connector
4. Pull the lead to check that it will not come
5. If the terminal comes off, bend up the pin
6. Connect:
NOTE:
The two connectors "click" together.
7. Check for continuity with a tester.
NOTE:
If there in no continuity, clean the terminals.
G
Be sure to perform the steps 1 to 7 listed
G
above when checking the wireharness.
For a field remedy, use a contact revitalizer
G
available on the market.
Use the tester on the connector as shown.
G
1 - 6
Connector
G
two or three times.
off.
1 and reinsert the terminal into the con-
nector.
Connector
G
GEN
INFO