Initialization; Automatic Reconditioning - Motorola IMPRES WPLN4108 Mode D'emploi

INITIALIZATION

In order for the features of Motorola IMPRES batteries and the
Adaptive Charging System to be fully available, the data contained in
Motorola IMPRES batteries must be initialized by the charger the first
time it is charged. This process is indicated by a STEADY YELLOW
light on the charger indicator (the same as if the battery were
reconditioning). The process is automatic, includes an initial
reconditioning of the battery, and begins charging upon completion of
this process. This process requires time to initialize the battery, so the
battery should be left in the charger for approximately 12 hours to
complete the process. Do not remove the battery from the charger until
the STEADY GREEN light is on.

AUTOMATIC RECONDITIONING

The Motorola IMPRES Adaptive Charger, when used in conjunction
with a Motorola IMPRES battery, has the ability to determine when it is
appropriate to recondition the battery (required to remove memory
issues in IMPRES batteries).
When an IMPRES battery is properly inserted into the charger, the
charger determines if it is appropriate to recondition the battery. If the
battery needs reconditioning, the charger automatically indicates a
STEADY YELLOW. This process may take up to 12 hours to complete,
depending upon the state of charge and capacity rating of the battery
when it is inserted.
It is important to note, for this process to be effective, the IMPRES
battery must be allowed to complete the recondition/recharge process.
Leave the battery in the charger until the charger indicates a STEADY
GREEN.
At the completion of the recondition cycle, the charger automatically
recharges the IMPRES battery.
7