Setting The Date And Time - Gigaset E630 Mode D'emploi

Gigaset E630/E630A / SUG US en / A31008-M2503-R301-1-3S43 / starting.fm / 8/29/19
Handset
On the base station
¤
Press and hold the Registration/Paging key on the base station (approx. 3 sec.).
On the handset
¤
Handset
ting: 0000)
If the handset is already registered with four bases, select the base to be replaced by
the new base.
Once registration is complete, the handset returns to idle status. The internal number of the
handset appears in the display, e. g. INT 1. If not, repeat the procedure.

Setting the date and time

Set the date/time so that the correct date and time can be assigned to incoming calls and to
enable the alarm to be used.
¤
Press the display key Time
or, if the date and time have already been set:
¤
OK
The active cursor position flashes
. . . switch between cursor positions with
Enter date:
¤
. . . using
Enter time:
¤
. . . using
Save settings:
¤
Press the display key Save. . . . Saved is shown in the display and
a confirmation tone sounds.
Return to idle status:
¤
Press and hold the End call key
The telephone is now ready for use.
10
. . . use to select
OK . . . an available base station is sought
OK
. . . use to select
enter the month, day and year in 8-digit format.
enter hours and minutes in 4-digit format.
Settings OK Registration
Settings OK Date/Time
. . . change cursor position with
OK Register
. . . enter system-PIN (default set-
Calls Time
Date/Time
Date:
08.15.2019
Time:
00:00
Back Save
en fr es