REBER 9340 N Notice D'utilisation Et Entretien page 60

SUGGESTED TIMES OF WELDING
Bag thickness
95 - 105 mi.
145 - 155 mi.
INFO:
Sealing time could be different using different kind of bags even if thickness is the same; we
suggest to test welding after changing welding time.
IMPORTANT
If the machine is not used for a long period and/or in the case of non-adequate or low
temperatures, it is recommendable, before using the machine, to try it once without using the
bag and keep the machine working in vacuum conditons for some seconds.
AUTOMATIC USE
1) Put the food which is to be vacuum preserved in a bag of adeguate size, leaving about 5
cm from the edge of the bag and the food.
2) Lift the cover up (4).
3) Place the open side of vacuum bag in the vacuum chamber (6), between the gaskets (5).
4) Close the cover and press pump switch (1). This will start vacuum operation.
5) As soon as vacuum pump starting, slightly press with both hands the cover so as it sticks
to the surface of the bag. After a few seconds the depression created by the pump will permit
to release the cover, while the machine will keep on suction.
USER INTERVENTION
Every operation will stop when pressing pump switch (1).
User can start welding operation, by pressing welding switch (2), during vacuum operation.
User can change from automatic to manual use, during vacuum operation, by pressing and
holding pump switch (2); in this case welding operation should be manually operated by
pressing welding switch (2).
MANUAL USE
1) Put the food which is to be vacuum preserved in a bag of adeguate size, leaving about 5
cm from the edge of the bag and the food.
2) Lift the cover up (4).
3) Place the open side of vacuum bag in the vacuum chamber (6), between the gaskets (5).
4) Close the cover and press pump switch (1). This will start vacuum operation.
5) As soon as vacuum pump starting, slightly press with both hands the cover so as it sticks
to the surface of the bag. After a few seconds the depression created by the pump will permit
to release the cover, while the machine will keep on suction.
6) The indicator on red shows that the right vacuum level is reached.
7) Press welding switch (2) to start welding operation.
N.B.: Welding operation can be starter at any time during vacuum operation by pressing
welding switch (2).
END OF OPERATION
At the end of vacuum/welding operation unplug the machine.
Cod. 9707 N VACUUM UNIT DE LUXE INOX PROFESSIONAL
The machine permits the vacuum packaging conservation of food products, so as to extend
their conservation in time. It is possibile to use all kinds of vacuum-preservation bags and
food bags.
After connecting to a correct power supply, if the machine is programmed for automatic use
both LEDs will light on for about 20 seconds, if the machine is programmed for maual use,
the green LED will light on for about 20 seconds.
Standard factory regulations provide a welding time of about 5 time/power units (suitable for
standard vacuum bags with 95/105 micron thickness), and automatic use.
Welding Time
6 / 7
12 / 15
60