Use Of The Machine - REBER 9340 N Notice D'utilisation Et Entretien

Cod. 9340 N - 9340 NAUS - 9340 NCSA - 9342 N (S-T-R-B) - 9346 N (F) - 9348 N (F) - 9344 N

USE OF THE MACHINE

Introduce the supply cable plug into a socket with suitable voltage. The unit is ready for
operation.
Press switch (1.) to start the air pump and air suction. Press the switch again to stop the unit.
When the air pump is working, press switch (2.) to operate the welding bar until the automatic
relay switch on. The unit stops automatically after a pre-determined time or by pressing the
on/off switch.
The green LED (4) also acts as welding time meter: during welding it flashes as many times
as the number of time/power units set.
The red LED lights up when a sufficient vacuum level has been achieved. Nevertheless
welding can be postponed to reach a higher vacuum level; this operation does not cause any
damage to the unit.
CHANGING THE DEFAULT SETTINGS
SEALING TIME
- Connect the unit
- Press and keep pressed the seal switch
- Press and keep pressed the start switch
- Wait at least 2 sec. to start defaults settings
- Press and release the start switch as many times as the number of time/power units to be
set (each press and release is one time/power units of seal – each time the green led lights)
- Release the switches
Default sealing time is 7 time/power units
Be careful! don't set more then 9 time/power units or the teflon protection of the sealing bar
can burns
TO SET TO DEFAULT AGAIN
- Press and keep pressed the two switches
- Connect the unit
TO CHANGE FROM THE AUTOMATIC TO MANUAL USE
- Disconnect the unit
- Press and keep pressed the start switch
- Connect the unit
- Wait the green led light
TO CHANGE FROM THE MANUAL TO AUTOMATIC USE
- Disconnect the unit
- Press and keep pressed the seal switch
- Connect the unit
- Wait the green led light
VACUUM PACKAGING IN BAGS
Introduce the product into a bag suitable for vacuum food preservation; leave at least 3 cm
free room from bag opening.
Lift the cover (6.) and place the bag (in well spread conditions) on the welding bar (9.), on
the left of the slide (11.). Make sure that the open side of the bag is inserted in the vacuum
chamber (8.). ( picture1 )
Introduce the cable plug into a socket and start the air pump by pressing switch (1.). Slightly
press your hands on the cover (6) to produce an initial depression in the vacuum chamber,
until the bag starts adhering to the product (pressing as long as vacuum packaging has been
completed is not necessary).
When the vacuum level is reached, the welding start automatically .
After welding the unit stops.
Cod. 9340 N – 9340 NAUS – 9340 NCSA– 9342 N (S-T-R-B): Push laterally the opening
valve of the cover (7.) to lift the cover and remove the bag.
56