Samson AirLine 88 Serie Manuel Du Propriétaire page 7

Quick Start
In order for your wireless system to work correctly, both the receiver and transmitter must be set
to the same channel.
Follow this basic procedure for setting up and using your AirLine 88x Headset wireless system:
Physically place the CR88x receiver where it will be used, and extend the antennas vertically.
The general rule of thumb is to maintain "line of sight" between the receiver and transmitter so
that the person using or wearing the transmitter can see the receiver.
With the CR88x powered off, connect the included power adapter. Turn the CR88x on
momentarily to confirm that the unit is receiving power. You'll see the LED display light up.
Then turn the CR88x power off.
With your amplifier or mixer off
and volume control all the way
down, connect the CR88x receiver
output jack to the mic or line
level input of a mixer or amplifier
using the balanced XLR output or
unbalanced 1/4" line level output.
Turn the Level knob on the CR88x
completely counterclockwise, then
turn its power on.
Press the SCAN button for more than 2
seconds (the display will start to flash quickly)
on the front of the CR88x receiver to scan
for an available channel. Once the optimal
channel is selected the receiver will enter IR
Set mode. The display will flash slowly in IR
Set mode.
If you want to set a transmitter to the
receiver's currently selected channel, press
and hold the SCAN button for more than 10
seconds (until the display flashes slowly) to
enter IR Set mode directly.
Make sure the AH8 Headset transmitter
is fully charged (see section "Charging the
AH8 Transmitter"). Turn on the power to the
transmitter by pressing and holding the Power
button for 3 seconds; the indicator LED will
light yellow when the button is pressed and
turns green when released and the AH8 is
powered on.
AirLine 88x Headset Wireless System
. Plug receiver into audio system 6. Press Select button to change channel
7