Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
CR88x Receiver Features - Rear Panel
1.
DC Input - Connect the supplied power adapter here, using the strain relief as shown in the
illustration below. WARNING: Do not substitute any other kind of power adapter. Doing so
can cause severe damage to the CR88x and will void your warranty.
2.
BALANCED OUTPUT - Use this electronically balanced low impedance (600 Ohm) XLR jack
when connecting the CR88x to professional (+4dBu) audio equipment. Pin wiring is as
follows: Pin 1 ground, Pin 2 high (hot), and Pin 3 low (cold).
3.
UNBALANCED OUTPUT - Use this unbalanced high impedance (5K Ohm) 1/4" jack when
connecting the CR88x to consumer (-10dBV) audio equipment. Wiring is as follows: tip hot,
sleeve ground.
14
Using the strain relief: Gather up a loop of
wire and pass it through the strain relief,
then pass the adapter plug through the
loop in order to create a knot.
Publicité
Table des Matières
