Samson AirLine 88 Serie Manuel Du Propriétaire page 16

Troubleshooting
Issue
No Audio
Distorted Audio
Audio Dropout
Receiver will not power
on
Transmitter will not
power on
(LED lights RED)
Unwanted noise or
interference
16
Solutions
Make sure that the transmitter and receiver are both
powered on.
Ensure the AH8 transmitter's batteries are fully charged.
Check that the transmitter is not muted.
Confirm that the CR88x adapter is correctly connected
and plugged into an electrical outlet.
Turn on the CR88x receiver.
Make sure the CR88x audio output connections are
securely connected.
Ensure that the receiver and transmitter are in line of
sight with one another.
Check the receiver and audio input device level controls.
Ensure that the transmitter and receiver are set to the
same operating channel. If unsure, reset the channel by
following the steps in the "Quick Start".
The receiver output level or audio input device level may
be too high.
The input gain on the transmitter (AH8) may be too high.
The transmitter may be too far away from the receiver.
Move it closer to the receiver, or reposition the antennas.
Remove any sources that may cause RF interference
such as cell phones, cordless phones, lighting
equipment, computers, metal structures, etc.
Check the adapter to ensure it is properly connected and
plugged into an outlet providing power.
Ensure the AH8 transmitter's batteries are fully charged.
If using multiple systems, make sure none of the
systems are operating on the same channel. If the
problem persists, change one or all of the systems
channels.