Kärcher B 300 RI LPG Mode D'emploi page 27

9.5.4 Change the motor oil and the oil filter
neues Bild
9.5.5 Check brake fluid status
WARNING
Risk of burns!

To change the motor oil and motor oil filter, allow the
vehicle to cool down until there is no longer a risk of
burns.
1 Oil filler cap
2 Oil dipstick
3 Engine oil filter
Note
A warm motor facilitates the draining of the motor oil.
Prepare a collection container for at least 10 litres

(2.7 gallons) of oil.
Switch off engine.

Unscrew oil drain plug.

Remove oil cap.

Drain off oil.

Unscrew the oil filter.

Clean the intake and sealing areas.

Coat the washer of the new oil filter with oil before fitting

it.
Fit in the new oil filter and tighten it by hand.

Screw in the oil drain plug with the new seal.

Tightening torque: ...Nm
Fill in motor oil.

For oil type and filling quantity refer to Chapter "Techni-
cal specifications".
Close oil cap.

Let the motor run for approx. 30 seconds.

Wait at least 5 minutes.

Check engine oil level.

Check for leaks.

Deliver the old oil to the respective collection centres.

1 Lever for steering wheel adjustment
2 Brake fluid container
3 Filling level
If necessary, refill DOT brake fluid currently commer-

cially available.
Have the brake fluid changed by Customer Service in

accordance with the inspection checklist (ICL).
26
-
EN 27