Date And Time Setting - Velleman IVSPROM1 Guide D'installation Rapide

5.3 DVR power on
•
This device should be operated only with the type of power source indicated on the manufacturer's label.
Connect the indicated AC power cord to the power adapter, and plug into an electrical outlet.
Note: Before the DVR is powered on, make sure that (1) the cameras are connected and power-supplied
for the detection of the camera video system to be correct, and (2) a monitor (either LCD or CRT monitor,
not incl.) is connected to the DVR for correct video output detection.
•
Switch on the DVR with the power switch on the back of the device. It will take about 30s for the DVR to
initialize.
Note: To ensure that your DVR works constantly and properly, it's recommended to use an UPS,
Uninterruptible Power Supply (not incl.), for continuous operation.

5.4 Date and time setting

Before operating your DVR, please set the date and time on your DVR FIRST.
Note: DO NOT change the date or time of your DVR after the recording function is activated. Otherwise,
the recorded data will be disordered and you will not be able to find the recorded file from backup by time
search. If users change the date or time accidentally when the recording function is activated, it's
recommended to clear all HDD data, and start recording again.
Note: when using the DVR for the first time, leave it powered on for at least 48 hours continuously after
the date & time is set correctly. To replace the internal battery, refer to APPENDIX 6 in the full user
manual.
•
Right-click to enter the DVR password with the password keypad. The default administrator password is
0000.
•
The status will be changed from
•
Right-click to show the main menu, and select "QUICK START"
GENERAL
TIME SETUP
EXIT
5.5 Clear hard disk
•
It's recommended to clear all data in the hard disk when using this DVR for the first time to ensure the
recorded data are not mixed with other data previously saved in the same hard disk.
•
Right-click to show the main menu, and select "SYSTEM"
•
The DVR will reboot when HDD data are cleared. For details, refer to §5.3.2 in the full user manual.
TOOLS
SYSTEM INFO
USB BACKUP
DVD BACKUP
EXIT
09.11.2010
IVSPROM1
(key lock) to (administrator).
QUICK START
DATE
TIME
SYSTEM
BAUD RATE
HOST ID
R.E.T.R
AUTO KEY LOCK
CLEAR HDD
RESET DEFAULT
REMOTE CONTROL ID
SERIAL TYPE
VIDEO FORMAT
VERSION
7
"TIME SETUP" to set the date & time.
2009 / NOV / 17
15 : 35 : 53
"SYSTEM INFO" "CLEAR HDD".
2400
000
5
NEVER
HDD-0
SUBMIT
000
RS485
NTSC
1019-1008-1010-1010
©Velleman nv