Electrical Connection - GE UVW9301 Manuel De L'utilisateur Et Instructions D'installation

INSTALLING THE HOOD (Cont.)
A
Vented Installations
Connect the house ducting to the damper on the
hood body. Seal all connections with duct tape
(Do not use screws).
B
Recirculation (Non-vented)
NOTE: A recirculation box, a charcoal filter, and a
bracket are included with the hood and are necessary
for recirculation installation.
1. Attach the recirculation box to the duct over
mounting bracket with 4 machine screws (J).
2. Connect the ducting from the exhaust outlet on
the hood to the recirculation box. Use duct tape
to seal the connections on the recirculation box
and the exhaust outlet.
Recirculation Box
Use tape
(Do not use screws)
18
Installation
Ceiling
House
Ducting
Duct Cover
Mounting
Bracket

ELECTRICAL CONNECTION

1. Remove the electrical junction box cover.
2. Remove the electrical box knockout.
Electrical Box
Knockout with
Strain Relief
3. Feed the Power Supply Cable through the hole
and secure with a strain relief.
4. Attach the white lead of the power supply (A) to
the white lead of the range hood (D) with a wire
nut. Attach the black lead of the power supply (B)
to the black lead of the range hood (C) with a wire
nut. Connect the house ground wire under the
green grounding screw (E).
House Wiring
B
C
Hood Wiring
5. Reattach the electrical junction box cover.
E
A
D
29-6326