Fitting The Hose/Cable Harness To The Recaro Seat - RECARO C 6000 Notice De Montage

Warning!
Ensure that you neither exceed nor fall short of the torque listed above.
If the torque is insufficient, the screws will work loose whilst you are driving. The thread might be
damaged if the torque is too high. The risk of an accident and being injured whilst driving exists in
both cases.
The vehicle must be stopped immediately if a screw works loose and the screws must be replaced
by new screws or with the bolt adhesive and tightened to the stipulated torque.

3.6 Fitting the hose/cable harness to the RECARO seat

Important note:
The hose/cable harness must be fitted to the RECARO seat when it is outside the vehicle.
If a hose/cable harness has already been fitted to the seat you should remove it and dispose of it.
Warning:
During the installation, ensure that the electrical and pneumatic connections do not become
contaminated or damaged, in order to guarantee a secure contact.
L
1
1. Fit the hose/cable harness (1) from the adapter kit to the RECARO seat.
2. Connect up the pneumatic (2) and the electrical (3) connectors.
RECARO Automotive Seating
2
3
1 hose/cable harness
2 Pneumatic connector
3 Electrical connector
K0236
Page 14