RECARO C 6000 Notice De Montage page 46

S
3. Attach the cover (1) to the EPS module and plug in the electrical connector (2).
4. Push the clip mounted on the cable into the corresponding hole in the EPS bracket.
Important note:
When carrying out any installation work, the stipulated torque must always be observed:
T
5. Carefully tip the RECARO seat onto its back. Ensure that you lay the seat on a clean, soft surface in
order to prevent damage or soiling.
6. Use the end clips (2) fastened to the cable harness to attach the hose/cable harness adapter (1) to
the RECARO adapter. Attach the edge clip (4) to the original console. Observe the cable routing
shown on the image.
7. Attach the air connection (3) on the hose/cable adapter to the air connection on the console.
RECARO Automotive Seating
1
4
1 Cover
2 Electrical connection
2
K0323
1
2
3
1 Hose/cable harness
adapter
2 End clip
3 Air connection
4 End clip
K0333
Page 19