RECARO C 6000 Notice De Montage page 43

Warning (risk of entrapment):
There is a risk of your fingers being crushed or trapped when moving the seat.
3. Screw the four rear screws (2) from the installation kit into the adapter (hand-tight only).
Warning:
The screws in the kit are micro-encapsulated and should never to be used more than once.
The micro-encapsulation will become ineffective if they are repeatedly used and the permanent
securing of the screw connection can no longer be guaranteed.
N
1
2
4. Move the seat as far back as possible and tilt the seat cushion upward. Take note of the installation
instructions.
5. Screw the two screws (2) from the installation kit into the front of the adapter (finger-tight only).
6. Move the seat as far forward as possible and tilt the seat cushion upward.
7. Tightly screw the four screws (3, 4) at the rear into the adapter using the stipulated torque.
Torque: M8 screws: 25 Nm ± 2 Nm
8. Move the seat as far back as possible again and tilt the seat cushion upward. Tighten the two screws
(2) with the stipulated torque.
(T30 Torx adapter).
Torque: M8 screws: 25 Nm ± 2 Nm
RECARO Automotive Seating
1 RECARO seat
2 Front screws - M8 from installation kit
3 Centre screws - M8 from installation kit
4 Rear screws - M8 from installation kit
3
4
Page 16