Storage And Transport; Disposal And Recycling - Scheppach HCP2600 Traduction Des Instructions D'origine

• Remove the spark plug (21) only with the mounting
tool supplied.
• Clean / replace spark plug
• Refit the spark plug in reverse order
Electrode spacing (Fig. 22)
The electrode distance must be 0.8 mm.
Important note in case of repair:
When returning the device to the service station for
repair, please note that the device must be sent free
of oil and petrol.
Cleaning the appliance (Fig. 23)
Remove any foreign objects that have accumulated
around or behind the muffler, on the unit, and around
shifting elements.
Use a brush or a soft cloth.
Service information
Please note that the following parts of this product
are subject to normal or natural wear and that the fol-
lowing parts are therefore also required for use as
consumables.
Wear parts*: spark plug, belt, hose, lance, Nozzles
and attachments, air filter
* Not necessarily included in the scope of delivery!

11. Storage and Transport

Preparing the unit for storage
Water should not remain in the unit for long periods
of time. Sediments or minerals can deposit on pump
parts and "freeze" pump action. If you do not plan to
use the pressure washer for more than 30 days, fol-
low this procedure:
1. Rinse suction hose with filter attachment (23). To
do so, immerse the filter in a bucket of clean water
and simultaneously run the high-pressure cleaner
in low-pressure mode. Rinse for one to two min-
utes.
2. Shut off the engine and let it cool, then remove
all hoses. Disconnect spark plug (10) wire from
spark plug (21)
3. Empty the pump of all pumped liquids by pulling
the recoil handle (15) about 6 times. This should
remove most of the liquid in the pump.
4. Draw RV antifreeze (non-alcohol) into the pump
by pouring the solution into a 3-foot section of
garden hose connected (19) to inlet adapter and
pulling recoil handle (2) twice. If available, use
PumpSaver in place of RV antifreeze and follow
package instructions.
5. Store unit in a clean, dry area.
Transport ot the high-pressure cleaner
• Switch off the high-pressure cleaner.
• Tipp the machine in your direction and roll the ma-
chine to the desired location.
30 | GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58

Disposal and recycling

The equipment is supplied in packaging to prevent
it from being damaged in transit. The raw materials
in this packaging can be reused or recycled. The
equipment and its accessories are made of various
types of material, such as metal and plastic. Never
place defective equipment in your household refuse.
The equipment should be taken to a suitable collec-
tion center for proper disposal. If you do not know the
whereabouts of such a collection point, you should
ask in your local council offices.