Publicité
Les langues disponibles
Les langues disponibles
13.
Use spacer blocks as shown in Figure 16 to
ensure that gate is square and level. On one
side of the gate, extend cross brace along
the gate to the opposite upright (noting one
side will be adjacent to hinge) to determine
cross brace length (Fig. 16). Mark provided
screw holes with a pencil as shown (Fig. 16
inset). Pre-drill through the marks using a
drill bit and then secure brace together using
the #8 x ³/
" blunt end screws provided (item
8
L from component list).
14.
Attach brace to the uprights. Pre-drill one end
of the brace through the provided screw hole
(Fig. 17). Secure brace to the upright using
the upright using the #8 x ¾" screws provided
(item M from component list). Repeat this step
at the other end of the brace (Fig. 18).
1
/
"
8
(Fig. 16)
(Fig. 17)
(Fig. 18)
7
Publicité
