Publicité
Les langues disponibles
Les langues disponibles
10.
Once gate is aligned and adjusted correctly,
snap on decorative hinge covers (Fig. 12).
6
11.
Once hinges are installed and gate is aligned,
place the latch template at desired height
at the edge of the post closest to the gate.
Mark and pre-drill holes using a
for the center screw hole and using a
drill bit for the top and bottom screw holes
(Fig. 13).
Align the latch to the pre-drilled holes and
secure to post using two 1" screws (Fig. 14).
(Fig. 12)
12.
Align the striker along the edge of the gate
upright, in the closed position with the latch.
Mark the two holes on the front of the striker
5
/
" drill bit
(Fig. 15). Mark the third hole on the side of
8
3
/
"
the striker, and pre-drill all three holes of the
32
striker using a
gate using three 1" screws.
(Fig. 13)
(Fig. 14)
3
/
" drill bit. Secure striker to
32
(Fig. 15)
Publicité
