Wiring; Connecting The Videophone; Connecting A Strike Plate - Philips WelcomeHive Pro Outdoor4 Notice

3. Wiring

In order to avoid the risk of interference and malfunction, do not pass the wire for your
videophone through the same sheath as the electrical wires.
Note: Do not under any circumstances double wires to increase the wire size.
Notes: To check that the product is not faulty, it is recommended that you make a
connection over a short distance (3 m of wire). If symptoms are identical, there is a product
fault. Otherwise check the installation and wire used.
a. Connecting the videophone (monitor, intercom panel and camera, see fig. 1, fig. 2 or fig. 3)
Wires to use: 2 wires 1 mm
- Ensure proper connection of the wires, following one of the wiring diagrams according to
the desired configuration.
- Be sure to refer to the labelling on the back of the monitor and the back of the intercom
panel.
b. Connecting a strike plate (or electric lock) or an automated gate
To connect your strike plate or gate to the Philips WelcomeHive Pro intercom panel, please
refer to the connections below:
GB15
minimum or 2 wires 1.5 mm
2
Wiring with external power supply
BUS (DS) PL
*Exit but-
Power supply
Wiring without external power sup-
ply
BUS (DS) PL S+
*Exit
button
Max 12V – 250mA
WelcomeHive Pro Outdoor4 - Outdoor8 / V4
.
2
1 2 3
S+ S-
Remove the
jumper
ton
*Optional exit button
1 2 3
S-
Jumper
in posi-
tions
1 and 2
*Optional exit button