Connecting To A Power Source - Toro Rake and Vac 51573 Manuel De L'utilisateur

Operation
Important: This blower is intended for outdoor,
residential use only. Do not use it indoors or for
commercial or industrial purposes.
Connecting to a Power
Source
Use only a polarized (i.e., one blade is wider than the
other), UL listed (CSA certified in Canada) extension
cord recommended for outdoor use. A polarized plug
will fit in a polarized cord only one way. If the plug
does not fit fully in the cord, reverse the cord. If it still
does not fit, purchase a polarized extension cord. Do
not change the plug in any way.
Extension Cord Length
100 ft.
150 ft.
Note: Do not use an extension cord over 150 feet.
Warning
If you do not fully seat the extension cord on the
inlet plug, the loose plug could lead to
overheating and cause a fire, possibly burning
you or others.
Ensure that you fully seat the cord on the plug
and use the cord lock feature to secure the cord.
Important: Check the power cord frequently
during use for holes in the insulation. Do not use a
damaged cord. Do not run the cord through standing
water or wet grass.
Minimum Wire Gage (A.W.G.)
16
14
5
Starting/Stopping/
Adjusting the Air Speed
Using the Concentrator
Nozzle Accessory
Install the concentrator nozzle into the blower tube to
help reach into narrow spaces or to move matted
debris off of hard surfaces.
Remove the concentrator nozzle when finished.
3351-953
m- -5119
m- -5123
m- -5123