LGB 29300 Mode D'emploi page 39

Example for Bit programming:
a loco shall run in reverse direction with user-programmed speed steps, analog
operation shall be possible:
Bit 1 = 1, Bit 2 = 0, Bit 3 = 4, Bit 4 = 0, Bit 5 = 16, Bit 6 = 0. 1+4+16=21.
Thus, program CV 29 to function value 21.
General programming procedure with 55015 Universal Remote:
- Registers CV1 through CV4 can be programmed directly by programming
the desired function value in the register.
- To program higher CVs:
- In register CV6, input the number of the register you want to program.
- Then input the desired function value in register CV5.
Example:
Set hand-over function to ON (program register CV54 to function value 3).
To program:
- Display shows "P --"
- Select register CV6 (press 6).
- Input 54 (register you want to program).
- Execute programming (press right arrow button).
- Display shows "P --"
- Select register CV5 (press 5).
- Input 3 (selected function value)
- Execute programming (press right arrow button).
When programming with the 55045, all function values are programmed directly.
37