LGB 29300 Mode D'emploi page 35

© DiskArt™ 1988
You can program the following registers:
Register Function values
CV1 Loco address
CV2 Starting voltage
voltage for speed setting 1 - if loco starts only
at a higher speed setting, increase value.
CV3 Acceleration (1 = fast, 255 = slow)
CV4 Braking (1 = fast, 255 = slow)
Hint:
When programming with the 55015 Universal Remote, the following CVs are
programmed by input of the number of the desired CV in CV6 and then input
of the desired function value in CV5 (see example below).
Available Factory
pre-set
(00-22) [3]
(0-255) [5]
(1-255) [3]
(1-255) [3]
33