LGB 29300 Mode D'emploi page 38

Register Function values
CV57 Command for function terminal F2 (see CV51)
CV58 Pause time (analog operation) (0.5 seconds
x function value)
When the polarity of the analog track voltage is
reversed, the loco waits for the programmed time
period, then accelerates in the new direction
CV60 Back-EMF: Max. adjustment factor
Specifies the max. increase or decrease of voltage
applied during each time interval (programmed
in CV61) 1 = small steps, 255 = large steps
The factory pre-set values of CV60 and CV61
are optimized for LGB motors.
CV61 Back-EMF: Adjustment frequency
Specifies how often per second the motor voltage
is adjusted - accordingly, the loco will react to curves
and grades immediately or with a short delay
0 = immediate adjustment, 255 = maximum delay
CV62 Back-EMF: Max. Adjustment
Limits the total adjustment in motor voltage. If there
is a very large load on the motor, the adjustment will
not exceed this value - for more realistic operations,
so that locos will slow a bit on grades.
0 = no adjustment, 255 = maximum adjustment
CV67 Speed steps programmed by user (see CV29):
to 28 speed steps are programmed in CV67 to CV94.
CV94 With LGB MTS, every second value is skipped
(14 speed steps). Factory pre-set speed steps:
7, 9, 11, 13, 16, 20, 24, 28, 32, 36, 42, 48, 54, 60,
68, 76, 84, 92, 102, 112, 124, 136, 152, 168, 188,
208, 230, 255
Pre-set values for user-programmable speed steps:
8, 16, 24, 32, 40, 48, 56, 64, 72, 80, 88, 96, 104,
112, 120, 128, 136, 144, 152, 160, 168, 176, 184,
192, 208, 224, 240, 255
Hint: The speed steps are factory pre-set and pro-
gramming is not necessary. We recommend the
55045 MTS PC Decoder Programming Module for
programming.
Available Factory
pre-set
[10]
(0-255) [0]
(1-255) [10]
(0-255) [5]
(0-255) [255]
(0-255)