John Bean EHP System IV E AT Instructions D'utilisation page 72

Operation Manual - EHP System IV E AT - Tire Changer
10.3 HANDLING INSTRUCTIONS
ALWAYS WEAR GLOVES WHEN UNCRATING THE MA-
CHINE TO PREVENT SCRATCHES OR ABRASIONS DUE
TO CONTACT WITH PACKING MATERIALS.
The shipping box is mounted in a steady wooden pallet.
The machine should be transported only with an appropri-
ate lifting device (fork lift) Fig.1.
Uncrating: Pay attention when cutting the banding or dur-
ing any other operation which may be hazardous.
Figure 1.
After removing the shipping box check for any visible dam-
age to the machine and its components, notify the carrier
immediately of any damage.
For installation assistance call your JBC Representative.
10.4 PACKAGING REMOVAL
The material of the packing (plastic bags, polystyrene, nails,
screws, wood etc.) shall not be left behind and shall not be
left at children reach since they may be possible hazards.
Place the above mentioned materials in proper trash con-
tainer and dispose following any local regulations.
10.5 PRE-INSTALLATION AND INSTALLATION IN-
STRUCTIONS.
Refer to MH 310-320 User Manual.
- Page 72 -