John Bean EHP System IV E AT Instructions D'utilisation page 26

E
F
A
B
a
4
26
4.1-1
c
b
4.1-2
4.1-3
3
4.1-4
Operation Manual - EHP System IV E AT - Tire Changer
C.
Press down and hold, WITH
from the right: the turntable turns clockwise.
H
Lift the pedal and the turntable turns counter-clockwise.
D.
Open the bead breaker arm. Press down and hold, WITH
LEFT FOOT, the
this you operate the bead breaker blade and the arm
will move towards the machine. Release the pedal: the
G
bead breaker blade will retract.
DANGER OF LEG TRAPPING
E.
The push button on the handle allows to release the
arms and drive the mount/demount tool in the correct
D
position.
1.
To unlock and let the slide with the tool go up: push the
button firmly with the forefinger, in the direction of the
arrow (A, Fig. 4.1-2).
C
2.
To unlock and let the slide with the tool go down: push
the button with the thumb in the direction of the arrow,
until the resistance increases (B, Fig. 4.1-2).
3.
To lock: push the button firmly with the thumb (C, Fig.
4.1-2).
DANGER OF HAND CRUSHING
F.
Press bead seater/inflator pedal on left side of the
machine down (1, Fig. 4.1-3): air will come from inflation
hose end (2, Fig. 4.1-3).
Only for Tubeless wheel models:
F1. Press bead seater/inflator pedal (1, Fig. 4.1-3) on
left side of the machine half way down: air will come
2
from inflation hose end only (2, Fig. 4.1-3).
F2. Press the key on the Tubeless Beading Nozzle
(3, Fig.4.1-3), then press the pedal all the way down
decisively (1, Fig.4.1-3); a high pressure air jet exits
the Tubeless Beading device.
WARNING:
NOZZLE FIRMLY.
Note: Air simultaneously continues to exit the hose
connected to the tire.
WARNING:
ONCE BEADING IS COMPLETE, IMMEDIATELY
STOP INTRODUCING AIR.
Operator's Manual
RIGHT FOOT, the first pedal
second pedal from the right: by doing
HOLD THE TUBELESS BEADING