Slope Setting; Tilt Function - QEO FL 150H-G Mode D'emploi

EN

SLOPE SETTING

Press this button
is below the sign. Change the sign with the buttons
digit. Set the slope values with these buttons. Press the button
the button again long to select the slope setting of the Y axis. The slope setting of the Y axis is the
same as above. After 8 sec. without entry the instrument will automatically store the values set. For
confirmation the instrument will beep. Then, the TILT mode preparation will start (3 status).

TILT FUNCTION

Powering on the laser the TILT function will be activated automatically. „TILT" is flashing during the
activation procedure. When the activation is completed (after 90 sec approx.) „TILT" is indicated perma-
nently.
Press button to switch this function on/off.
When the TILT function is active:
If the laser is disturbed, the rotation stopps and the laser beam and „TILT" will flash. The laser will not
re-level automatically.
If required self-levelling procedure can be reactivated with button
This instrument has three TILT status:
Activation
=„TILT" flashes slowly during the activation, the instrument in not yet ready for use
Function active
= TILT" is indicated permanently
TILT alarm
= „TILT" is flashing quickly and the rotation stopps.
VIBRATION-WIND-SECURITY
Press this button to activate the VWS mode. The VWS function automatically activates the TILT function.
This function allows continuous operation during periods of vibration and wind. If a significant movement
occurs the laser stops rotating and the TILT LED starts flashing. Press the VWS button to cancel. Press
the VWS button again to re-activate.
32
for 2 sec. to enter into the slope mode. The X symbol and „+" will flash. The curser
(VWS FUNCTION)
. Press the button short to go to the next
again to select the next digit. Press
.