Operation - QEO FL 150H-G Mode D'emploi

EN
E

OPERATION

Mount the laser onto a tripod.
Set up the instrument as upright as possible to allow the self-levelling
system to function within the range and to make sure that the maximum
slope range is available.
POWER ON
Power on the instrument on with button .
After switching on the instrument the display shows automatically:
- the battery status of the instrument
- the preparation of the TILT mode (the TILT LED is blinking slowly); if the instrument is not disturbed
within 30 sec, the TILT mode is active; (see also: TILT function)
- status SLOPE +00.000 %
- if a remote is active and can receive a signal the indication = ; if no remote is active the indication
is =
- the remote control channel selected last
At the same time the self-levelling procedure starts.
If the self-levelling procedure is completed the laser starts rotating with 600 rmp.
SELF LEVELLING PROCEDURE / DISPLAY ILLUMINATION
If the TILT function is activated and the level is disturbed (rotation stopps) the self-levelling procedure can
be started from this position if required. Press the button short.
Please check if the instrument has been disturbed.
Press the button long (2 sec.) to switch on / off the display illumination of the remote control.
31