Operation With The Remote Control; Slope Setting - QEO FL 155H-G Mode D'emploi

EN
REMOTE CONTROL CHANNEL
Press this button short to select the remote control channel (ciruclarly from CH2 to CH 9 and from
A to F = 14 channels).
The channels of the remote can be changed in order to avoid that several units on one construction site
disturb each other.

OPERATION WITH THE REMOTE CONTROL

REMOTE CONTROL
I
1. Slope function
I
2. Slope setting % up
3. Slope setting % down
4. SLEEP/MAN function
10
5. ON/OFF button
6. TILT function
1
6
7 . VWS function
8. Channel selection remote control
7 2
9. Self levelling function / Display illumination
of the remote control
8
3
10. Rotating speed
11. Area shield section -Y
9
4
12. Area shield section -X
13. Area shield section +X
5
14. Area shield section +Y
11
14
12
13

SLOPE SETTING

Press this button for 2 sec. to enter into the slope mode. The X symbol and „+" will flash. The curser
is below the sign. Change the sign with the buttons . Press the button short to go to the next
digit. Set the slope values with these buttons. Press the button again to select the next digit. Press
the button again long to select the slope setting of the Y axis. The slope setting of the Y axis is the
same as above. After 8 sec. without entry the instrument will automatically save the values set. For
confirmation the instrument will beep. Then, the TILT mode preparation will start (3 status).
29