Display Indication - QEO FL 155H-G Mode D'emploi

EN
D
OPERATION
Mount the laser onto a tripod.Chann
Set up the instrument as upright as possible to allow the self-levelling system
to function within the range and to make sure that the maximum slope range is
available.
OPERATION - INSTRUMENT KEYPAD
Channel selection
Channel setting button
remote control
POWER ON
Power on the instrument on with button
After powering on the instrument the display shows automatically:
- the battery status of the instrument
- the preparation of the TILT mode (the TILT LED is blinking slowly); if the instrument is not disturbed
within 30 sec, the TILT mode is active; (see also: TILT function)
- status SLOPE +00.000 %
- if a remote is active and can receive a signal the indication =
is =
- the remote control channel selected last
At the same time the self-levelling procedure starts.
If the self-levelling procedure is completed the laser starts rotating with 800 rmp.

DISPLAY INDICATION

TILT mode indication
TILT function indication
VWS mode indication
VWS function indication
Indication of remote
Remote status indication
control active / inactive
Remote channel indication
Channel selection indication remote control
28
ON/OFF button
On/off button
.
I
Indication of the area
shielded section
; if no remote is active the indication
Rotating speed indication
Rotating speed indication
X axis grade value
Indication slope value X axis
Y axis grade value
Indication slope value Y axis
Power indication
Battery status indication