Niko 360-45011 Mode D'emploi page 49

360-45011
390-40011
- Vout max X: adjustable between 6 – 10V; standard 10V
- Fade up X: adjustable between 5 – 60s; standard 10s
- Fade down X: adjustable between 5 – 60s; standard 10s
- Off delay: only adjustable below CH1, but functions identically for all active channels (max.
3 channels).
After the last detected movement, the system counts down the 'off delay'. If the set time elapses
before a new movement is detected, the light level is dimmed to Vout in all active channels.
In case of motion detection before the 'off delay' has elapsed, the light level is automatically
adjusted in all active channels (zones).
Adjustable between 1 – 60min; standard 10min.
- Cut off X: The 'cut off' is typical for channel X.
If the 'off delay' has elapsed and the active channels are dimmed to Vout min., the 'cut off
delay' starts counting down. If no movement is detected and the 'cut off delay' elapses, the
load (lighting) for this channel is switched off.
Adjustable between: 0min – unlimited. Standard 8min.
- Loadshedding X: If a 'loadshedding' switch is integrated in a system (see fig.), Vout max. X
cannot rise above the set value if the switch is switched on.
Adjustable between: 0 – 10V; standard 5V.
Application: close the 'loadshedding' switch in order to save energy at specific moments, so
the lighting is only switched on at a lower level of daylight.
Adjust Settings:
- Copy settings:
1) Custom to Backup: the settings in custom mode are copied to backup mode
2) Backup to Custom: the settings in backup mode are copied to custom mode, so making
changes is possible.
3) Factory to Custom: the factory settings are loaded in custom mode.
4) Factory to Backup: the factory settings are loaded in backup mode.
You are recommended to always make a backup of the settings. After you have done this, preferably
EN 49