Web Interface; First Access To The Web; Inserting An Sd Card; Maintenance - Videotec MAXIMUS MMX Manuel D'instructions

6.2 Web interface

Browsers supported (the latest version):
Microsoft Edge, Google Chrome, Mozilla
Firefox.
6.2.1 First access to the web pages
The first operation in configuring the device consists
in connecting to the web interface.
To access the web interface of the product, simply
use a browser to connect to http://ip_address.
On first access, the Home page will be displayed.
Additional information about setting up and using
the device is available in: www.pelco.com/exsite-
enhanced-2

6.3 Inserting an SD Card

For instruction about opening and closing
the camera, please refer to Manual A.
For onboard video storage capabilities, please insert
an industrial grade microSD card into the slot as show
(Fig. 3, page 9).
Fig. 3
MNLCMMXCAM_1905_EN

7 Maintenance

Before doing any technical work or
maintenance on the device, make sure that
potentially explosive atmosphere is not
present.
Do not open the device when powered and
in explosive atmosphere.
Read the product Manual A before
performing any operation.
Please provide the device serial number when
requesting any replacement parts.

7.1 Factory Default

It is possible to reset to the factory default settings.
Carry out mechanical operations with reference to
Manual A of the product.
Follow the procedure below:
• Disconnect the power supply to the unit.
• Open the housing and remove the slide.
• Set the reset dip switch to ON (SW1, 4.2 Housing
board description, page 6).
• Re-insert the slide and close the housing.
• Power the unit. Wait for 3 minutes.
• Disconnect the power supply to the unit.
• Open the housing and remove the slide.
• Set the reset dip switch to OFF (SW1, 4.2 Housing
board description, page 6).
• Re-insert the slide and close the housing.
• Power the unit.
Once the factory default procedure has
finished, you need to configure the unit as
described in chapter (6.1 Default IP address,
page 8).
9