Rolair 13GR30HK30 Manuel D'utilisation page 3

INSTALLATION ~ OPERATION ~ MAINTENANCE
COMPRESSOR DISCHARGE AIR MAY CONTAIN HYDROCARBON
Make a permanent record of the model and serial number of your new air compressor here. You'll save time and expense by
including this reference information when requesting service or replacement parts.
Place & Date of Purchase
Model
Serial #
With shut-off valve to outside line(s) closed and tank pressure at 0 PSI, record the amount of time it takes to build tank
pressure in the space provided below. Periodically test your compressor against this pump-up time to determine if it is
operating correctly. If time test is considerably off, contact your local ROLAIR
CONGRATULATIONS ON THE PURCHASE OF YOUR NEW ROLAIR
Immediately upon receipt of your air compressor and prior to completely uncrating, the following steps should be taken:
Step 1) Remove box and inspect compressor for damage that may have occurred during shipment. If any damage is
found, demand an inspection from the carrier. Ask the carrier how to file a claim for shipping damages. Freight
damage is not covered by ROLAIR
Step 2) Insure that adequate lifting equipment is available for moving the air compressor.
Step 3) Record the model number and serial number from the unit nameplate on the front of your owner's manual. Space
is also provided for pump-up time test to be performed and recorded upon initial start-up of air compressor.
606 South Lake Street > P.O. Box 346 > Hustisford, WI 53034-0346 > 920.349.3281 > fax 920.349.3691 > www.rolair.com
WARNING
AND OTHER CONTAMINANTS; THEREFORE, DO NOT USE
DISCHARGE AIR FOR BREATHING.
RECORD OF PERTINENT INFORMATION
From 0 to _____PSI
Date Min. Sec.
RECEIVING INSTRUCTIONS
warranty.
®
STATIONARY
AIR COMPRESSOR
MANUAL
Volts
Hz
HP
representative to arrange service.
®
From 0 to _____PSI
Date Min.
3
Sec.
COMPRESSOR!
®