Maintenance; Troubleshooting - Rolair 13GR30HK30 Manuel D'utilisation

Regular maintenance insures trouble-free operation. Your new compressor represents the finest engineering and
construction available. However, even the finest machinery requires periodic maintenance. A good maintenance program will add
years of service to your air compressor. The following is recommended as a minimum maintenance program. For your protection,
disconnect power supply after each day's operation and drain air from system before performing any maintenance.
For maximum performance and service life, we recommend using ROLAIR
Recommendation
Check Oil Level
Drain Moisture from Tank(s)
Inspect Air Filter(s)
Check for Unusual Noise or Vibration
Inspect Belt Guard
Check for Air or Oil Leaks
Clean Exterior of Air Compressor
Check Condition of Vibration Pads
Tighten/Re-torque Bolts*
Check Belt Tension
Check Operation of Safety Valve
Change Compressor Oil**
Clean/Change Air Filter
Perform Pump Up Time Test
Check Operation of System Controls
Check Air Tanks for Dents/Leaks
Determine pump type using suffix of model number (Example: V5180K30 uses a K30 pump.)
Pump Type
Head Bolts
Cylinder Bolts
Bearing Carrier Bolts
Connecting Rod Bolts
Flywheel

MAINTENANCE

OIL TABLE
Daily Weekly Monthly Quarterly
X
X
X
X
X
X
X
X
X
X
X
X
X
X
TORQUE CHART (INCH/LB)
K17/K18 K24/K25
243 243
182 182
130 130
121.5 121.5
382 382

TROUBLESHOOTING

Premium Quality compressor oil.
®
*Check and re-torque (see chart on pg. 7) only after
pump has completely cooled to room temperature.
**Always make sure crankcase vent (breather) is free
and unobstructed when changing or checking oil.
MAINTENANCE HINTS:
1) Use a soap/water solution to check for air leaks.
2) Never clean filters with a flammable solvent.
3) Re-torque head bolts only after pump has cooled.
4) Move motor 1/4" and roll belts back on to increase belt
tension on electric units.
X
5) Never weld on air tank(s).
X
6) Use heat to loosen Loctite seal on drain valves, engine
pulleys and flywheels before attempting to remove.
K28 K30
347 347
330 330
130 130
121.5 173.6
477 477
10
K35 K50 K60
347 694 347
330 521 330
130 165 165
173.6 217 217
477 607 607
K100
694
521
165
199.7
694