ESYLUX RC 130i Mode D'emploi page 12

Focus LED ON/OFF (programming mode)
Press this button once to switch off the focus LED – press again to switch it
back on. The focus LED briefly lights up to indicate that it is active.
NB: When the focus LED is switched off, a signal is still acknowledged by two
flashes of the "blue mode" LED.
Alarm mode (programming mode)
If movement is detected, the detector switches ON for 1 second and OFF
for 1 second. This continues for 30 seconds (flashing phase). Then the light
GB
switches to continuous mode for the rest of the on-period, or another alarm
phase is triggered if motion is detected. To cancel, press the
end the alarm function, press the
Holiday mode (programming mode)
This function activates the connected lighting for 1 to 8 hours once a
predefined light value has been reached, regardless of whether motion is
detected or not. Once this period of continuous lighting has elapsed, the
motion detector switches back to automatic mode. The process is repeated
every day.
Setting: one hour is added each time the holiday mode button is pressed.
The set number of hours is indicated by the blue mode LED. When the
holiday mode button is pressed for the first time, the blue mode LED lights
up for a prolonged period and is then briefly interrupted: this means 1
hour is set. When the holiday mode button is pressed for the second time,
the blue mode LED lights up for a prolonged period and is then interrupted
twice: this means 2 hours are set. This process continues up to a setting
of 8 hours. If the button is pressed for a ninth time the system returns to 1
hour. Once the required number of hours has been programmed, close
programming mode to activate the function.
To cancel, press the
To quit holiday mode, press the
Reset
Resets the device to automatic mode. This cancels alarm mode, holiday
RESET
mode, impulse mode, test mode and the time setting.
Reset – in programming mode
Resets the device to the default settings. Cancels all values set by remote
control and resets all functions. The device operates according to the
preset factory settings (10 lux/2 min/max. electronic range).
NB: If the continuous lighting OFF function is to be used further, it must
be re-enabled.
Master X
This is used to activate the continuous lighting OFF function (see
Continuous lighting ON/OFF) and to cancel the time settings.
12
button.
RESET
button.
button.
RESET
Electronic range adjustment
This function electronically increases the range by +15 % or decreases it
by -30 %. The
button. To
button reinstates the basic settings.