Installation And Connection - Oase BioMaster 250 Notice D'emploi

‐ EN ‐
Dismantling the unit head
It has to be removed for cleaning and maintenance
and for changing the filter media.
Prerequisite:
• The heater has been removed. (→ Removing the
heater)
• The connection unit has been removed.(→
Removing the connection unit)
• The pre‐filter has been removed. (→ Removing the
pre‐filter)
How to proceed:
 I
1. Hinge up the handle.
2. Undo the fasteners.
3. Remove the unit head.
Fitting the unit head
How to proceed:
 J
1. Check that the seal on the unit head is correctly po‐
sitioned.
– Clean the seal, replace it if damaged.
2. Ensure that the filter baskets are correctly assem‐
bled and aligned.
3. Fit the unit head onto the container.
– Ensure that the opening for the pre‐filter is
aligned to the recess in the filter baskets.
4. Lock the fasteners in place.
5. Hinge the handle down.
INSTALLATION AND CONNECTION
Order of tasks to be carried out:
1. Fit the unit feet (→ Fitting the unit feed)
2. Prepare the filter media (→ Cleaning/replacing the
filter media)
3. As an option: OASE HeatUp Retrofitting (heater)
(→ Retrofitting the heater)
4. Install the unit.
– Install the unit next to or under the aquarium.
Note the maximum head height. (→ Technical
data)
5. Establish the connections (→ Establishing the con‐
nections)
14
Fitting the unit feed
How to proceed:
 K
 Twist the rubber feet into the openings of the con‐
tainer base.
Retrofitting the heater
BioMaster 250/350/600 can be retrofitted with OASE
HeatUp.
 A holding ring is required for fitting (provided in the
delivery scope).
BioMaster
25
50
100
150
200
300
: Suitable : Particularly recommended
Prerequisite:
The pump is unplugged. (→ Switching off the unit)
N O T E
When the filter is filled with water, water may spill
when the heater is inserted.
 Take measures to collect any spillage.
How to proceed:
 L
1. Unscrew the blind plug counter‐clockwise and re‐
move.
2. Push the heater into the holding ring as far as it
goes.
– Tip: Moisten the glass bulb with water before in‐
serting.
3. Fit the heater. (→ Fitting the heater)
Establishing the connections
Assembling the suction unit
How to proceed:
 M
 Assemble the suction unit.
 Set the flow rate.
 Use a coin to turn the flow regulator in the hose
adapter to MAX.
BioMaster 250/350/600, BioMaster Thermo 250/350/600
250 350 600
  
  
  
  
 
–

– –