Bimar VM44 Notice D'instructions page 19

• Warning: don't use wet hand touch the working machine and don't cover the wind
outlet and inlet.
• Before each use, verify that the heater is in good condition and that the electrical cord
is not damaged: in the case of doubt, ask for professionally qualified help.
• Make sure that the cable is correctly positioned and that it is not in contact with hot
parts or sharp edges, nor wrapped around the device or twisted.
• The power socket must be easy to reach so the plug can be removed quickly in case of
emergency.
Use
Attention: the fan can be used only when completely and correctly assembled, that is
complete with its base.
Before each use, verify that the unit is in good condition, the electric cord is not
damaged, if the power cord is damaged, it must be replaced by the manufacturer or a
competent qualified electrician or a person with similar qualifications, in order to avoid
any risk.
The fan's functions can be controlled either with the keypad located on the control panel
or with the remote control.
Remote control is supplied without batteries; before use remote control open the
batteries holder placed on the back of remote control and insert 2 batteries LR03 1,5V
AAA. To remove batteries, open the batteries holder placed on the back of the remote
control, by sliding the cover to the outwards.
Insert the plug in the socket.
Ventilation:
1) To turn the fan on, press the "ON/SPEED" key on the remote control or the control
panel.
2) To select the desired speed in normal mode "
SPEED" key: on the control panel shows the selected speed (Low=minimum,
Med=medium, Hig=maximum) and "
Horizontal oscillation (right-left): this is controlled by the "SWING" key on the remote
control or the pushbutton panel (E). To eliminate this motion, press the "SWING" key
again.
Vertical inclination (high-low): it is regulated by gripping
the motor body and orienting it in the direction desired.
NOR
NOR
".
19/52
", repeatedly press the "ON-