Bimar VM44 Notice D'instructions page 17

ASSEMBLY
Attention: always unplug the appliance before you assemble the appliance.
If in doubt, have the appliance checked or assembled by a qualified professional person.
Attention: the fan can be used only when completely and correctly assembled, that is
complete with protection grids (rear and front).
For assembly, refer to below pictures.
Ventilator
1. Fasten the rear grid (5) to the motor casing, positioning the corresponding pins and
holes, and lock using the appropriate ring nut (4).
2. Insert the fan (3) on the motor shaft (6) and lock with the appropriate ring nut (2)
turning it tightly anti-clockwise.
3. Couple the front grid (1) with the rear grid (5) and lock with the plastic ring and
ensure the fastening with the appropriate locking screw (11). Having done this,
check that the protection grid is firmly coupled and fastened to the motor.
Wall installation
• The appliance must only be used if secured to a wall: the wall must be flat, smooth,
very stable (as the appliance could tip over) and resistant.
• Position the appliance far from other sources of heat, inflammable materials (curtains,
carpets, etc.), inflammable gases or explosive materials (spray cans).
• If the appliance is fitted to a wall, the same must be made of masonry and/ or of
resistant material (not of wood or synthetic material); follow the indications below for
installation:
- The wall fan must be installed at least 2 m above the floor
- Place the metal plate to the wall, make 3 holes in the wall, (before drilling holes is good
to measure the distance between the slots above), insert the screw anchors into the
holes, place the plate metal and tighten the screws as shown in Figure 2,
the wall's plate (10) making sure that the flap fits into the fixing plate (9) on the back
of the fan.
Fig.1 Fig.2
17/52
Fix the fan on
Fig.3