Bimar VM44 Notice D'instructions page 15

WARNINGS ABOUT BATTERIES
•
KEEP BATTERIES OUT OF THE REACH OF CHILDREN. Swallowing can lead to
chemical burns, perforation of soft tissue, and death. Severe burns can occur within 2
hours of ingestion. Seek medical attention immediately.
•
Do not allow children to replace batteries.
•
Always insert batteries correctly with regard to polarity (+ and -) marked on the
battery and the equipment. Do not short-circuit batteries. Do not charge batteries.
•
Do not force discharge batteries. Do not mix new and used batteries or batteries of
different types or brands.
•
Exhausted batteries should be immediately removed from equipment and properly
disposed of. Do not heat batteries. Do not weld or solder directly to batteries.
•
Do not dismantle batteries. Do not deform batteries.
•
Do not dispose of batteries in fire.
•
A lithium battery with a damaged container should not be exposed to water.
•
18 Do not encapsulate and/or modify batteries.
•
Store unused batteries in their original packaging away from metal objects. If already
unpacked, do not mix or jumble batteries.
•
Remove batteries from equipment if it is not to be used for an extended period of
time unless it is for emergency purposes.
•
Clean the battery contacts and also those of the equipment prior to battery
installation.
•
In case of leak from batteries, avoid any contact with it; in case of contact, wash the
affected part with water and seek medical attention.
INSTALLATION
• After removing the packing materials, check the integrity of the appliance; if you are
unsure, do not use it and ask for qualified professional help. The packing materials
(plastic bags, polystyrene foam, nails, etc.) must be kept out the reach of children
because they are potential sources of danger. Attention: any stickers or advertising
material applied to the grid removed before using the appliance. The manufacturer
declines all responsibility in case this is not safe working practices will be respected.
• Before connecting the appliance, check that the voltage values shown on the data
plate correspond to those of the electricity supply network.
incompatibility between the electric outlet and the plug of the appliance, have the
outlet replaced with another more suitable type by professionally qualified personnel,
who will make sure that the section of the wires of the outlet is appropriate for the
absorbed power of the product. In general, the use of adapters or extension cords is
not recommended; if their use is indispensable, they must conform to existing safety
standards and their current capacity (amperes) must not be less that the maximum of
the appliance.
• The power socket must be easy to reach so the plug can be removed quickly in case of
emergency.
15/52
In the event of