Install Batteries In Wireless Devices; Remote Control (Optional); Link All Devices To Wireless Network - Honeywell RedLINK Guide D'installation

2

Install batteries in wireless devices

When system wiring is complete, install batteries in all devices. Make sure
batteries are inserted properly (see polarity marks on illustrations below).
Thermostat

Remote control (optional)

M28475
3

Link all devices to wireless network

Press and release CONNECT
Flashing status light times out after 15
minutes of inactivity. Press
again if necessary.
69-2091EFS_C.indd 5
Français : voir la page 21 • Español: vea la página 41
M28472
Install 2 fresh AA
batteries
Outdoor air sensor (optional)
Install 3 fresh AA
batteries
Restore AC power, then press and release
the CONNECT button at the EIM. Wait for
green flashing light to begin linking devic-
es to the wireless network (see pages 6-7).
If the light stops flashing before you have
linked all devices, press CONNECT again.
M28495
CONNECT
Programmable models only
Install quick reference
M28473
card
Install 2 fresh AA
lithium batteries
M28476
If light does not flash, another EIM/
wireless adapter may be in wireless setup
mode. Exit wireless setup at the other
EIM/wireless adapter.
5
M28474
Continued on next page >>
69-2091EFS—05
3/11/2009 12:52:50 PM