Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Fuses:
Mains fuse: Si1 400 mA, slow-blow.
Operating voltage: Si2 1.25 A, slow-blow.
Separate supply/external instrument
supply: Si3 1.25 A, slow-blow.
Control voltage for locking system Si4
160 mA, slow-blow.
Caution!
Fuses of the incorrect amperage or
bridged fuses may cause irreparable
damage to the unit.
Housing:
Sheet steel housing with hinged lid
Colour:
grey-white, RAL 9002
Dimensions (W x H x D): 300 x 186 x 125
Weight:
Type of protection:
Humidity rating:
Ambient temperature range: 0° - 40° C
Installation position: horizontal or vertical
Data for loadings by external equipment:
Max. loading from connected
equipment: 1.1 A
(Secondary power pack 24 V/1.25 A)
Induced current consumption of control
relay 720.20(22) including both emer-
gency cutout relays is 150 mA; max.1.1 A
available for external equipment.
Load data for items of equipment usually
connected:
1 x 828 holding magnet: 325 mA
1 x 829 holding magnet: 650 mA
1 x 331 escape door release: 160 mA
1 x 3150 panic release: 300 mA
2 x 827 holding magnets: 500 mA
1 x 1337-10 door terminal: 60 mA
1 x 725 door control module: 10 mA
Max. 5 fire detectors,
total: 15 mA
1 x 1055-24 flashlamp: 250 mA
1 x 1037-10 piezoelectric hooter 20 mA
30
Caution!
In the unlocking without alarm mode, the
locking component and alarm transmitter
are jointly active.
By removing jumper J1, the continuous
unlocking function at the door terminal
(control unit terminal 3) can be disabled.
The control input terminal 3 is then only
able to perform the alarm reset function.
Continuous unlocking is then only possible
at terminal 40 (e.g. connection for central
control panel 725).
Door terminal 1337-10
approx. 4900 g
(1337-11 with concealed frame)
DIN 40050-IP 30
For actuation of the escape door
DIN 40040-F
control unit 720-20(22).
The door terminal 1337-10(11) is a control
and monitoring terminal which must be
installed alongside escape doors on the
site. The integral emergency switch (to DIN
VDE 0660 parts 200/207) in the door
terminal, which is easily identified by an
illuminated slam button (which itself lights
up when pressed), effects the immediate
unlocking of the door locking systems
when operated. A transparent, splinter-
proof plastic cover provides protection
against unintentional operation.
The integral key-switch can only be used
by authorized persons in possession of a
corresponding key. The key-switch controls
the switching commands for door locking
and unlocking, temporary unlocking and
resetting. Three LEDs relay the check-back
signals for the different operating modes.
Publicité
Table des Matières
