Changing The Fuses - Kärcher Tornado BR Trike Notice D'installation

English
Troubleshooting
Risk of injury!
!
Before working on the appliance,
always set the key switch to "O", remove
the key and disconnect the mains plug from
the battery charger.
n Drain off and dispose of dirty water and
any residual cleaning liquid.
If faults cannot be rectified with the aid of
this table, contact customer service.
Fault
Unit cannot be started.
Unit does not move.
Inadequate water flow rate.
Display: "Gas pedal"
Inadequate suction power.

Changing the fuses

The drive control/electronics module is
attached under the front panel. If a fuse has
to be changed, this front panel must be
removed.
n Loosen the screws on the housing.
n Change the fuse.
n Re-attach the front panel.
i
the inside of the front panel.
Remedial action
Check fuses F1 and F4 and, if required, change.
Check batteries; if required, replace.
Check fuse F5; if required, replace.
Check fresh-water level; if required, top up tank.
Check hoses for blockages; remove any blockages.
Set key switch to "O" and then back to "I" without
depressing the gas pedal.
Check fuse F3; if required, replace.
Clean container cover seals and check for leaks;
if required, replace.
Clean the fluff strainer on the intake neck of the suction
motor.
Clean squeegee blades on the suction bar; if required,
replace.
Check suction hose for blockages; remove any
blockages.
Check suction hose for leaks; if required, replace.
Operating Instructions BR/BD Trike
Information:
The fuse configuration is indicated on
17