Shutting Down The Applianceen; Transport; Storage; Care And Maintenance - Kärcher BD 50/60 C Ep Classic Mode D'emploi

Masquer les pouces Voir aussi pour BD 50/60 C Ep Classic:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Height
The bend of the suction lips upon con-
tact with the floor is influenced with the
height adjustment.
 Try adjusting the twist handles of
the height adjustment until the best
vacuuming result is achieved.
Cleaning
ATTENTION
Risk of damage to the floor covering.
Do not operate the appliance on the
spot.
 Insert the end of the extension ca-
ble as a loop in the strain relief
clamp.
 Connect the mains plug of the de-
vice to the extension cable.
 Insert the mains plug of the exten-
sion cable into a socket.
 Turn the program selection switch
to the desired cleaning program.
Lower the vacuum bar
 Pull the lever out and press it down;
the vacuum bar is lowered.
Note:
– For cleaning tiled floors, adjust the
straight suction bar in such a way
that cleaning is not done at an angle
of 90 degrees to the joints.
– The inclined position and the incli-
nation of the suction bar can be ad-
justed to achieve better suction re-
sults (see "Adjusting the suction
bar").
– If the waste water tank is full, the
float closes the suction opening and
the suction turbine runs at an in-
creased speed. If this is the case,
shut the vacuum off and drive to
empty the waste water tank.
8
Shutting Down the Appliance
 Set the program selection switch to
suction or vacuuming.
 Briefly drive forward and suck of the
remaining water.
 Raise the vacuum bar.
 Set the programme selector switch
to "OFF".
 Disconnect the mains plug from the
socket.
Drain off dirt water
WARNING
Please observe the local provisions re-
garding the wastewater treatment.
 Take the water discharge hose
from the support and lower above a
suited collection device.
 Crush or bend the dosing equip-
ment.
 Open the lid of the dosing equip-
ment.
 Drain off the dirt water - regulate the
water quantity by pressing or bend-
ing.
 Rinse the waste water tank with
clear water.
Drain off clean water
 Unscrew the lock of the fresh water
reservoir.

Transport

DANGER
Risk of injury! When loading or unload-
ing the machine, it may only be operat-
ed on gradients up to the maximum
value (see "Technical Specifications").
Drive slowly.
CAUTION
Risk of personal injury or damage!
Mind the weight of the appliance during
transport.
6
-
EN
 Press down and push the device
using the push handle.
 When transporting in vehicles, se-
cure the appliance according to the
guidelines from slipping and tipping
over.

Storage

CAUTION
Risk of personal injury or damage!
Consider the weight of the appliance
when storing it.
This appliance must only be stored in
interior rooms.

Care and maintenance

DANGER
Risk of injury! Set the programme se-
lector switch to "OFF" and disconnect
the mains plug prior to performing any
work on the device.
 Drain and dispose of the dirt water
and the residual fresh water.
Maintenance schedule
After each operation
ATTENTION
Risk of damage. Do not sluice the ap-
pliance with water and do not use ag-
gressive detergents.
 Drain off dirt water.
 Rinse the waste water tank with
clear water.
 Clean the outside of the appliance
with a damp cloth which has been
soaked in mild detergent.
 Check the fluff filter, clean if required.
 Clean the vacuum lips and the wip-
ing lips, check for wear and replace
if required.
 Check the brush for wear and re-
place if required (see "Maintenance
tasks").
Monthly
 Clean the seals between waste wa-
ter tank and cover and check for
tightness, replace if required.
Yearly
 Have the prescribed inspection car-
ried out by the customer service.

Publicité

Table des Matières
loading

Table des Matières