Adventys MOWI 7000 Guide D'utilisation page 15

Eliectrictli connection
- Unscrew the 4 screws of the bottom plate, located under the unit to access the connection terminal
block area.
- Prepare a sector cable equipped with 5 conductor caps wiring.
- Place the cord into the cable clamp and tighten the cable clamp to secure the power cords.
- Connect the 5 wires of the power cord to the terminal block in accordance with the following diagram.
Input Power Cord
- Replace the bottom plate by screwing the 4 screws.
- You can connect the power cord to a standard three phase plug 400 V +/- 10% of your electrical
installation.
MOWi 7000
Provide a sector cable with 1.5 mm² wires
Connecting Plate
Power Cord
Terminal connection cord
according with markings :
L1 (brown)
L2 (black)
L3 (grey)
N (blue)
Ground (green/yellow).
15