AL-KO CSA 2020 Mode D'emploi page 43

Help in case of malfunction
Malfunction Cause
The guide rail The saw
and saw chain is ten-
chain become sioned too
hot when run- tightly.
ning. Genera-
Oil tank is
tion of smoke.
empty.
The oil entry
hole and/or
groove of
the guide rail
are dirty.
Motor run- The saw
ning, but the chain is ten-
saw chain sioned too
does not tightly.
move.
Appliance
faults
Only sawdust The saw
is thrown out, chain is
rather than blunt.
wood chips.
The pole-
mounted
pruner must
be forced
through the
wood.
Appliance vi- Appliance
brates unusu- faults
ally.
Rechargeable The service
battery oper- life of the re-
ating time is chargeable
significantly battery has
shorter. expired.
442216_a
Remedy
Check the chain
tension. Re-ten-
sion the saw
chain.
Replenish the
saw chain oil.
Clean the oil en-
try hole and
groove of the
guide rail.
Check the chain
tension. Re-ten-
sion the saw
chain.
Contact an AL-
KO service cen-
tre.
Sharpen the
saw chain or
contact an AL-
KO service cen-
tre.
Contact an AL-
KO service cen-
tre.
Replace the re-
chargeable bat-
tery. Only use
genuine acces-
sories from the
manufacturer.
Malfunction Cause
Rechargeable Recharge-
battery can- able battery
not be contacts are
charged. dirty.
Recharge-
able battery
or charging
unit is defec-
tive.
Recharge-
able battery
is too hot.
NOTE
If you encounter any malfunctions that
are not listed in this table or that you can-
not rectify yourself, please contact our
customer service.
Remedy
Contact an AL-
KO service cen-
tre.
Replace the re-
chargeable bat-
tery or charging
unit. Only use
genuine acces-
sories from the
manufacturer.
Allow the battery
to cool down.
43