Dyna-Glo DGP700SSB Guide D'utilisation Et Mode D'emploi page 31

Cleaning the Burner Assembly - Make sure the grill is cool
1. Turn gas off at the control knobs and propane tank.
2. Disconnect LP-Gas cylinder from hose and regulator.
3. Remove warming rack, cooking grates, and heat tents.
4. Detach burner by removing the cotter pins at the back of the burner to detach it from the brackets.
5. Detach ignition wire from electrode by hand only. DO NOT use pliers or any other tool as it
may damage the electrode or wire.
6. Lift burner slowly.
7. Ensure all burner ports are clear of clogs. Use of a pin or paper clip works well.
8. Ensure burner is free from any damage. If damage is found, replace with new burner.
9. Ensure the end of the burner and primary air screen are clear of insect nests, dirt, or debris.
Re-installing the Burner
• Ensure the gas valve orifices are correctly
positioned inside burner inlet (venturi).
• The use of a flashlight may be necessary to
ensure the correct position.
• It is recommended to view the correct position
through the firebox vent holes as illustrated.
Re-installing the Charcoal Ignition Burner
• Ensure the Charcoal valve orifices are correctly
positioned inside burner inlet (venturi).
• The use of a flashlight may be necessary to
ensure the correct position.
• It is recommended to view the correct position
through the firebox vent holes as illustrated.
• Attach ignition wire to electrode and attach
burner to brackets with cotter pins.
Dual Fuel Grill
CARE AND MAINTENANCE
Burner Assembly
29