Klarstein 10033015 Mode D'emploi page 63

Problem Possible causes
The induction This is caused by the
hob technology of induction
makes a low cooking.
humming noise
when used on
a high heat
setting.
Fan noise A cooling fan built into your
coming from induction hob has come on to
the induction prevent the electronics from
hob. overheating. It may continue to
run even after you've turned the
induction hob off.
Pans do not 1 The induction hob cannot
become hot and detect the pan because it
appears in is not suitable for induction
the display. cooking.
2 The induction hob cannot
detect the pan because it
is too small for the cooking
zone or not properly centred
on it.
The induction Technical fault.
hob or a
cooking zone
has turned
itself off
unexpectedly, a
tone sounds and
an error code
is displayed
(typically
alternating with
one or two
digits in the
cooking timer
display).
What to do
This is normal, but the noise
should quieten down or
disappear completely when
you decrease the heat setting.
This is normal and needs no
action. Do not switch the power
to the induction hob off at the
wall while the fan is running.
Use cookware suitable for
induction cooking. See section
„Choosing the right cookware".
Centre the pan and make sure
that its base matches the size of
the cooking zone.
Please note down the error
letters and numbers, switch
the power to the induction hob
off at the wall, and contact a
qualified technician.
EN
63