Control List: 20 Points - Ducati HC 800 Manuel De Montage

812/00 corretto 26-09-2001 9:25 Pagina 34
Caution: Firmly fix the device as vibrations may reduce the bulb
lifetime.
3.8 Transmitter and receiver coding
The new transmitter ref. 6203 is already "PRE-CODED" in the
manufacturer workshop.
Press T1-T2-T3 keys Fig. 15 the pre-set codes are transferred
T1 .... Gate operator
T2.... Garage operator
T3...(T1+T2 at the same time) Antithef or other automation switch off
Important: To cancel the STANDARD coding or other coding,
keep the P1 key pressed for 15 seconds. This function completely
resets the receiver cancelling each coding in the memory.
In case you would like to change the transmitter coding, follow these
instructions:
1. Press the transmitter T1 and T2 keys at the same time (see
Fig.15) for approx. 10 seconds until the Led fixed light is on. From
this moment the transmitter is in the programming function, if the
keys are released the led turns off.
2. Press the key corresponding to the channel to be programmed ( ex.
T1, T2 or T3), the Led fixed light is on for approximately one
second.
3. Press T1 ( OFF ) and T2 ( ON ) keys in sequence composing your
coding string. At every release the led turn off. Ex. Pressing T1-T2-
T1-T2- you programme: OFF-ON-OFF-ON etc. up to 12.
You have 30 seconds to perform the programming, after this time if
the 12 codes are not entered, the transmitter will keep the previous
setting.
4. After the twelfth pulse the transmitter will blink THREE TIMES to
signal that the programming was accepted.
Important: we suggest to mark the numbers string you coded.
How to enter the new transmitter code in the programmer:
"SELF-LEARNING" function
Important: cancel the pre-set standard code keeping P1 key
pressed for 15 sec.
Then:
1. Press the programmer P1 key (only once!) the Led 2 will light up.
2. Press the previously programmed channel key on the transmitter
(T1-T2-T3) for some seconds until the Led 2 turns off.
The receiver is programmed.!
IMPORTANT: It will be possible to enter a second code in the CTR35
programmer receiver in order to access the pedestrian function directly
from the transmitter.
To activate this function:
1.Press P1 key twice in sequence, the Led 2 will turn on
2.With the transmitter transfer a signal pressing one of the keys T1or
T2 or T3 previously coded (see paragraph 3.8)
Important: the receiver will accept a code that allows this further
function only if different from the code previously set for the basic
functions and if set on a different key.

4.0 Control list: 20 points

We suggest to check the following points in order to be absolutely sure
to have made a correct assembly:
1. The dimensions of the gate shall not exceed the maximum limits
detailed at Page 1.
2. The gate wings shall be able to move correctly by hand.
3. Actuators shall be fixed in a TOUGH way and shall be perfectly
symmetrical.
4. Electric connections shall be carried out with care and attention.
5. In case no photocells were used, connect the terminal No.17 to
terminal No. 16 through a jumper.
34