Operation; Energy Saving Tips - Dometic CLASSIC RH418NTE Instructions De Montage Et De Service

Operation

• Air passing through the ventilation duct must not be preheated by any source of
heat.
• The ventilation duct must be kept free from any obstacles. Especially portable
multi socket outlets or portable power supplies, which can get warm, must not
be kept at the rear of the cooling device.
➤ Fix the cooling device through its fixing feet as shown (fig. b, page 7).
5.4 Mounting the sliding hinge (optional)
You can mount a sliding hinge that allows the cooling device door to be opened at
the same time as the door of the built-in cabinet.
➤ Mount the sliding hinge as shown (fig. c, page 7 to fig. f, page 8).
6 Operation
!
CAUTION! Health hazard!
Food may only be stored in its original packaging or in suitable
containers.
I
NOTE
• Before starting your new cooling device for the first time, you should
clean it inside and outside with a damp cloth for hygienic reasons
(please also refer to the chapter "Cleaning and maintenance" on
page 19).
• A few water drops may form inside the cooling device if it has been
cooling for a lengthy period. This is normal because the moisture in
the air condenses to water when the temperature in the cooling
device falls. The cooling device is not defective. Wipe it out with a
dry cloth if necessary.
6.1

Energy saving tips

• Choose a well ventilated location which is protected from direct sunlight.
• Allow warm food to cool down first before placing it in the cooling device to
keep cool.
• Do not open the cooling device more often than necessary.
• Do not leave the cooling device open for longer than necessary.
16
RH418NTE, RH418NTEG
EN