Handlebar Setting - ORTHOSCOOT NH1 Mode D'emploi

Handlebar setting

Now the vehicle must be adjusted to your height. Please read the following steps carefully and take all the time
you need for the setting. You should definitely try different settings, test-drive and compare before you finally
decide upon the setting. In case you cannot decide between two settings, please always choose the smaller one.
An aid which perfectly fits your needs is essential for an ergonomically correct handling.
At first, open the upper quick release skewer between
the T-handlebar unit and the handlebar stem.
Adjust the handlebar to your height and ensure that
the ball head snaps into the correct positioning hole.
ORTHOSCOOT NH1
®
Four different positioning holes are placed on the
handlebar stem. By pressing the ball head, the
T-handlebar unit can be removed from its locking and
can be shifted vertically.
Close the quick release skewer you opened before.
Now the handlebar has been properly set up and secu-
red.

37